next up previous contents
Next: Diffusion mass transfer in Up: Types of analysis Previous: Electrostatics   Contents


Stationary groundwater flow

The governing equations of stationary groundwater flow are [27]

$\displaystyle \boldsymbol{ v} = - \boldsymbol{k} \cdot \nabla h$ (328)

(also called Darcy's law) and

$\displaystyle \nabla \cdot \boldsymbol{ v} = 0,$ (329)

where $ \boldsymbol{v}$ is the discharge velocity, $ \boldsymbol{k}$ is the permeability tensor and $ h$ is the total head defined by

$\displaystyle h = \frac{p}{\rho g} + z.$ (330)

In the latter equation $ p$ is the groundwater pressure, $ \rho$ is its density and $ z$ is the height with respect to a reference level. The discharge velocity is the quantity of fluid that flows through a unit of total area of the porous medium in a unit of time.

The resulting equation now reads

$\displaystyle \nabla \cdot (- \boldsymbol{ k} \cdot \nabla h) = 0.$ (331)

Accordingly, by comparison with the heat equation, the correspondence in Table  (15) arises. Notice that the groundwater flow equation is a steady state equation, and there is no equivalent to the heat capacity term.


Table 15: Correspondence between the heat equation and the equation for groundwater flow.
heat groundwater flow
T $ h$
$ \boldsymbol{q}$ $ \boldsymbol{v}$
$ q_n$ $ v_n$
$ \boldsymbol{\kappa}$ $ \boldsymbol{k}$
$ \rho h$ 0
$ \rho c$ $ -$

Possible boundary conditions are:

  1. unpermeable surface under water. Taking the water surface as reference height and denoting the air pressure by $ p_0$ one obtains for the total head:

    $\displaystyle h = \frac{p_0 - \rho g z}{\rho g} + z = \frac{p_0}{\rho g}.$ (332)

  2. surface of seepage, i.e. the interface between ground and air. One obtains:

    $\displaystyle h = \frac{p_0}{\rho g} + z.$ (333)

  3. unpermeable boundary: $ v_n = 0$

  4. free surface, i.e. the upper boundary of the groundwater flow within the ground. Here, two conditions must be satisfied: along the free surface one has

    $\displaystyle h = \frac{p_0}{\rho g} + z.$ (334)

    In the direction $ \boldsymbol{n}$ perpendicular to the free surface $ v_n = 0$ must be satisfied. However, the problem is that the exact location of the free surface is not known. It has to be determined iteratively until both equations are satisfied.


next up previous contents
Next: Diffusion mass transfer in Up: Types of analysis Previous: Electrostatics   Contents
guido dhondt 2018-12-15